GUIDELINES FOR THE PREPARATION OF M. Tech. PROJECT REPORTS
\nProject reports should be typed neatly only on one side of the paper with 1.5 or double line spacing on a A4 size bond paper (210 x 297 mm). The margins should be: Left – 1.25″, Right – 1″, Top and Bottom – 0.75″.
\nThe total number of reports to be prepared are
\nOne copy to the department
\nOne copy to the concerned guide(s)
\nTwo copies to the sponsoring agency
\nOne copy to the candidate.
\n3. Before taking the final printout, the approval of the concerned guide(s) is mandatory and suggested corrections, if any, must be incorporated.
\n6. For making copies dry tone Xerox is suggested.
\n7. Every copy of the report must contain
\nInner title page (White)
\nOuter title page with a plastic cover
\nCertificate in the format enclosed both from the college and the organization where the project is carried out.
\nAn abstract (synopsis) not exceeding 100 words, indicating salient features of the work.
\nInner title page
\nAbstract or Synopsis
\nThe organization of the report should be as follows
\nAcknowledgments
\nTable of Contents
\nList of table & figures (optional)
\nUsually numbered in roman
\nChapters (to be numbered in Arabic) containing Introduction-, which usually specifies the scope of work and its importance and relation to previous work and the present developments, Main body of the report divided appropriately into chapters, sections and subsections.
\nThe chapters, sections and subsections may be numbered in the decimal form for e.g. Chapter 2, sections as 2.1, 2.2 etc., and subsections as 2.2.3, 2.5.1 etc.
\nThe chapter must be left or right justified (font size 16). Followed by the title of chapter centered (font size 18), section\/subsection numbers along with their headings must be left justified with section number and its heading in font size 16 and subsection and its heading in font size 14. The body or the text of the report should have font size 12.
\nThe figures and tables must be numbered chapter wise for e.g.: Fig. 2.1 Block diagram of a serial binary adder, Table 3.1 Primitive flow table, etc.
\nThe last chapter should contain the summary of the work carried, contributions if any, their utility along with the scope for further work.
\nReference : The references should be numbered serially in the order of their occurrence in the text and their numbers should be indicated within square brackets for e.g. [3]. The section on references should list them in serial order in the following format.
\nFor textbooks – A.V. Oppenheim and R.W. Schafer, Digital Signal Processing,Englewood, N.J., Prentice Hall, 3 Edition, 1975.
\nFor papers – Devid, Insulation design to combat pollution problem, Proc of IEEE, PAS, Vol 71, Aug 1981, pp 1901-1907.
\nOnly SI units are to be used in the report. Important equations must be numbered in decimal form for e.g.
\nV = IZ ………. (3.2)
\nAll equation numbers should be right justified.
\nThe project report should be brief and include descriptions of work carried out by others only to the minimum extent necessary. Verbatim reproduction of material available elsewhere should be strictly avoided. Where short excerpts from published work are desired to be included, they should be within quotation marks appropriately referenced.
\nProper attention is to be paid not only to the technical contents but also to the organization of the report and clarity of the expression. Due care should be taken to avoid spelling and typing errors. The student should note that report-write-up forms the important component in the overall evaluation of the project
\nHardware projects must include: the component layout, complete circuit with the component list containing the name of the component, numbers used, etc. and the main component data sheets as Appendix. At the time of report submissions, the students must hand over a copy of these details to the project coordinator and see that they are entered in proper registers maintained in the department.
\nSoftware projects must include a virus free disc, containing the software developed by them along with the read me file. Read me file should contain the details of the variables used, salient features of the software and procedure of using them: compiling procedure, details of the computer hardware\/software requirements to run the same, etc. If the developed software uses any public domain software downloaded from some site, then the address of the site along with the module name etc. must be included on a separate sheet. It must be properly acknowledged in the acknowledgments.
\nSponsored Projects must also satisfy the above requirements along with statement of accounts, bills for the same dully attested by the concerned guides to process further, They must also produce NOC from the concerned guide before taking the internal viva examination.
\nThe reports submitted to the department\/guide(s) must be hard bounded, with a plastic covering.
\nSeparator sheets, used if any, between chapters, should be of thin paper<\/p>\n
(On a separate sheet)
\nNAME OF THE INSTITUTION
\nAddress with pin code
\nDepartment of \u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026..<\/p>\n
CERTIFICATE
\nCertified that the project work entitled \u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026… carried out by Mr.\/Ms. \u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026.\u2026\u2026\u2026\u2026\u2026\u2026.., USN\u2026\u2026\u2026\u2026\u2026\u2026\u2026..\u2026\u2026\u2026, a bonafide student of \u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026.in partial fulfillment for the award of Master of Technology in \u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026…\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026.\u2026\u2026\u2026 of the Visveswaraiah Technological University, Belgaum during the year \u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026… It is certified that all corrections\/suggestions indicated for Internal Assessment have been incorporated in the Report deposited in the departmental library. The project report has been approved as it satisfies the academic requirements in respect of Project work prescribed for the said Degree.
\nName & Signature of the Guide Name & Signature of the HOD Signature of the Principal
\nExternal Viva
\nName of the examiners Signature with date
\n1
\n2.<\/p>\n
Certificate issued at the Organization where the project was carried out
\n(On a separate sheet, If applicable)
\nNAME OF THE INDUSTRY \/ ORGANIZATION
\nAddress with pin code
\nCERTIFICATE<\/p>\n
Certified that the project work entitled \u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026… carried out by Mr.\/Ms . \u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026.., USN\u2026\u2026\u2026\u2026\u2026\u2026\u2026..\u2026\u2026\u2026, a bonafied student of \u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026.in partial fulfillment for the award of Master of Technology in \u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026…\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026.\u2026\u2026\u2026 of the Visveswaraiah Technological University, Belgaum during the year \u2026\u2026\u2026\u2026\u2026\u2026\u2026\u2026… It is certified that, he\/she has completed the project satisfactorily<\/p>\n
Name & Signature of the Guide Name & Signature of the Head of organization
\nWhen once dissertation copies are ready for submission
\nSubmit 4 copies of the dissertations to the respective Regional Offices with a copy of the letter marked to the office of the Registrar (Evaluation).
\nEnsure that the Panel of Examiners, in the suggested format, has been already submitted as also the Internal Assessment Marks (out of 50) and
\nAfter the Conduct of Viva-Voce, dispatch the marks lists directly to the Registrar (Evaluation)<\/p>\n","protected":false},"excerpt":{"rendered":"
GUIDELINES FOR THE PREPARATION OF M. Tech. PROJECT REPORTS Project reports should be typed neatly only on one side of the paper with 1.5.<\/p>\n","protected":false},"author":1,"featured_media":0,"comment_status":"closed","ping_status":"closed","sticky":false,"template":"","format":"standard","meta":[],"categories":[55,181,14,178,114,113,48,139,1],"tags":[197,199,143,198],"yoast_head":"\n